PhoenixMiner v4.2

[falcomann]

PhoenixMiner v4.2

PhoenixMiner is Ethash (ETH, ETC, Muiscoin, EXP, UBQ, etc.) miner that  supports both AMD and Nvidia  cards (including in mixed mining rigs). It runs under Windows x64 and Linux x64 and has a developer  fee of 0.65%. This means that every 90 minutes the miner will mine for us, its developers, for 35 seconds.

PhoenixMiner also supports Ubqhash for mining UBQ, ProgPOW for mining BCI, and dual mining Ethash/Ubqhash with Blake2s.

Download for Windows
Download for Linux

Changes in version 4.2c (since 4.1c):

• Added support for dual mining Ethash and Blake2s on Nvidia GPUs
• Added new Nvidia kernels v3 with slightly higher hashrate and lower power consumption (up to about 1-1.5% less power). The new kernels are supported only on GTX1050/1060/1070/1080/Ti GPUs and are enabled by default on these GPUs. Note that you can't use these kernels for dual-mining, only -nvkernel 2 works for dual mining on Nvidia.
• Added new command-line option -nvkernel to select the old (v1 CUDA kernels from PhoenixMiner 3.5), newer (v2 introduced with PhoenixMiner 4.0), or the latest CUDA kernels (v3). The possible values are 0 (auto; the default, selects the best kernel for each GPU), 1 , 2, or 3 (forces v1, v2, or v3 kernels respectively). Note that only v2 CUDA kernels support dual mining.
• Added experimental support for ProgPOW mining of Bitcoin Interest (BCI). Note that the kernels are not optimized and only work on AMD.
• You must add -coin bci to the command line (or COIN: bci to your epools.txt file) in order to mine BCI.
• Added parameter to enable or disable driver-specific optimizations on Nvidia GPUs. Use -nvdo 1 (the default is 0) to enable the optimizations. This won't change hashrate (or will change it only slightly) but can make the cards more stable depending on the concrete Nvidia driver.
• Added support for EthereumStratum/2.0.0 protocol (use -proto 5 if the pool requires it).
• AMD hardware control code was rewritten, now should be more stable and work on older cards too
  
• Added command-line option -fcm to set the way fans are controlled (AMD/Windows only). The possible values are 0 (auto; the default behavior), 1 (use VBIOS/driver), 2 (force custom control of the fans regardless of VBIOS/drivers fan curves, etc). Use -fcm 2 if the fans are not controlled properly or at all
• Added support for Radeon VII
  
• Added support for Windows AMD drivers 19.3.3
• Increased the maximum supported DAG epoch to 329. This should be fine for at least a year or so.
• Added support for direct mining without DAG switching of Yocoin (YOC), Bitcoiin2Gen (B2G), Ethersocial (ESN), Atheios (ATH), and REOSC.
• See the -coin parameter in Readme.txt for more information.
• Fixed the slower DAG generation on Vega and Radeon VII GPUs
• Fixed the problem with the watchdog timer when solo mining
• Other small improvements and fixes.